1. What is New Total Depth of Reservoir?

The New Total Depth of Reservoir refers to the adjusted depth where water is collected and stored for various uses. It is calculated based on the difference in elevation between the Full Reservoir Level (FRL) and the original bed, minus the height above the bed.

2. How Does the Calculator Work?

The calculator uses the formula:

Where:

• \( D \) — New Total Depth of Reservoir (m)
• \( H \) — Difference in the Elevation (FRL and Original bed) (m)
• \( h_o \) — Height above Bed (m)

Explanation: This formula calculates the new depth by subtracting the height above the bed from the elevation difference between the full reservoir level and the original bed.

3. Importance of Reservoir Depth Calculation

Details: Accurate calculation of reservoir depth is crucial for water resource management, ensuring adequate storage capacity, and planning for water supply and irrigation systems.

4. Using the Calculator

Tips: Enter the difference in elevation (FRL and original bed) and the height above the bed in meters. Both values must be non-negative.

5. Frequently Asked Questions (FAQ)

Q1: Why is it important to calculate the new total depth of a reservoir?
A: It helps in determining the actual storage capacity and ensures efficient water management and distribution.

Q2: What units should be used for input values?
A: Both inputs should be in meters (m) for consistency and accurate results.

Q3: Can the height above bed be greater than the elevation difference?
A: No, as it would result in a negative depth, which is not physically possible for a reservoir.

Q4: How precise should the input values be?
A: For engineering purposes, values should be measured as precisely as possible, typically to at least two decimal places.

Q5: Are there any limitations to this calculation?
A: This calculation assumes a simple geometric relationship and may not account for complex reservoir shapes or other hydrological factors.