Formula Used:
From: | To: |
The Constant K is a parameter that depends on the soil characteristics at the base of the well, specifically for fine sand conditions. It is used in hydrogeological calculations to determine various well properties and behaviors.
The calculator uses the formula:
Where:
Explanation: The constant K is calculated as half of the cross-sectional area of the well, which is a standard relationship for fine sand conditions at the well base.
Details: Accurate calculation of constant K is crucial for proper well design, groundwater flow analysis, and determining the hydraulic properties of wells in fine sand conditions.
Tips: Enter the cross-sectional area in square meters. The value must be valid (greater than 0).
Q1: What does the constant K represent?
A: The constant K represents the soil-dependent parameter at the base of the well, specifically calibrated for fine sand conditions.
Q2: How is cross-sectional area measured?
A: Cross-sectional area is typically measured as the area of the well's horizontal cross-section at the base level.
Q3: Does this formula apply to all soil types?
A: No, this specific formula (K = 0.5 × Acs) is specifically designed for fine sand conditions at the well base.
Q4: What units should be used for cross-sectional area?
A: Cross-sectional area should be provided in square meters (m²) for consistent results.
Q5: Can this calculator be used for other soil types?
A: This calculator is specifically designed for fine sand conditions. Different soil types may require different formulas and coefficients.