Indicated Power Of Four-Stroke Engine Calculator

Formula Used:

\[ IP = \frac{k \times MEP \times L \times A_c \times N}{2} \]

Number of Cylinders:

Mean Effective Pressure:

Stroke Length:

Area of Cross Section:

m²

Engine Speed:

rad/s

Indicated Power:

Unit Converter ▲

Unit Converter ▼

From:	To:

1. What is Indicated Power?

Indicated power is the total power produced due to combustion of fuel within the IC engine's cylinder in one complete cycle neglecting any losses. It represents the theoretical power output of an engine before accounting for mechanical losses.

2. How Does the Calculator Work?

The calculator uses the formula:

\[ IP = \frac{k \times MEP \times L \times A_c \times N}{2} \]

Where:

\( IP \) — Indicated Power (W)
\( k \) — Number of Cylinders
\( MEP \) — Mean Effective Pressure (Pa)
\( L \) — Stroke Length (m)
\( A_c \) — Area of Cross Section (m²)
\( N \) — Engine Speed (rad/s)

Explanation: This formula calculates the power generated by the engine based on the pressure developed in the cylinders, engine geometry, and rotational speed.

3. Importance of Indicated Power Calculation

Details: Calculating indicated power is essential for engine performance analysis, efficiency calculations, and comparing different engine designs. It helps engineers optimize engine parameters for better performance.

4. Using the Calculator

Tips: Enter all values in the specified units. Number of cylinders must be a positive integer, while other parameters must be positive numbers. The calculator will compute the indicated power in watts.

5. Frequently Asked Questions (FAQ)

Q1: What is the difference between indicated power and brake power?
A: Indicated power is the theoretical power produced in the cylinders, while brake power is the actual power available at the engine output shaft after accounting for mechanical losses.

Q2: Why is the formula divided by 2 for four-stroke engines?
A: In four-stroke engines, power is produced only every two revolutions of the crankshaft, hence the division by 2.

Q3: How is mean effective pressure measured?
A: MEP is typically calculated from indicator diagrams that show pressure variation in the cylinder during the engine cycle.

Q4: What factors affect indicated power?
A: Engine size, combustion efficiency, air-fuel ratio, compression ratio, and engine speed all affect indicated power output.

Q5: Can this calculator be used for two-stroke engines?
A: No, this specific formula is designed for four-stroke engines. Two-stroke engines have a different power calculation formula.