Resisting Force Of Cylinder Along Longitudinal Section Per Mm Length Calculator

Formula Used:

\[ F = \sigma_c \times 2 \times L_{cylinder} \times t \]

Circumferential Stress Due To Fluid Pressure (σc):

Pascal

Length Of Cylindrical Shell (Lcylinder):

Meter

Thickness Of Wire (t):

Meter

Resisting Force (F):

Unit Converter ▲

Unit Converter ▼

From:	To:

1. What Is The Resisting Force Of Cylinder Along Longitudinal Section Per Mm Length?

The resisting force of a cylinder along its longitudinal section per mm length refers to the force that opposes deformation or failure in the longitudinal direction of a cylindrical structure under internal pressure or other loads.

2. How Does The Calculator Work?

The calculator uses the formula:

\[ F = \sigma_c \times 2 \times L_{cylinder} \times t \]

Where:

\( F \) — Resisting force (Newton)
\( \sigma_c \) — Circumferential stress due to fluid pressure (Pascal)
\( L_{cylinder} \) — Length of cylindrical shell (Meter)
\( t \) — Thickness of wire (Meter)

Explanation: This formula calculates the resisting force along the longitudinal section of a cylinder by considering the circumferential stress, length of the cylinder, and thickness of the material.

3. Importance Of Resisting Force Calculation

Details: Calculating the resisting force is crucial for structural integrity analysis, pressure vessel design, and ensuring safety in engineering applications involving cylindrical structures.

4. Using The Calculator

Tips: Enter circumferential stress in Pascal, length in meters, and thickness in meters. All values must be positive numbers greater than zero.

5. Frequently Asked Questions (FAQ)

Q1: What is circumferential stress?
A: Circumferential stress (hoop stress) is the stress exerted circumferentially in both directions on particles of the cylinder wall when subjected to internal pressure.

Q2: How does length affect the resisting force?
A: The resisting force is directly proportional to the length of the cylindrical shell - longer cylinders will have greater resisting forces.

Q3: What units should be used for input values?
A: Stress should be in Pascal, length in meters, and thickness in meters for consistent Newton output.

Q4: Can this formula be used for any cylindrical material?
A: Yes, the formula applies to any homogeneous cylindrical material, though material properties are accounted for in the stress value.

Q5: What are typical applications of this calculation?
A: This calculation is essential in pressure vessel design, pipeline engineering, storage tank design, and any application involving cylindrical structures under pressure.