Theis Equation for Drawdown Calculation:
| From: | To: |
The Drawdown at Time Interval t1 calculation is based on the Theis equation, which estimates the drawdown in an aquifer at a specific time interval given known parameters at another time interval. This is essential for groundwater flow analysis and well testing.
The calculator uses the Theis equation:
Where:
Explanation: The equation calculates the drawdown at one time interval based on known drawdown at another time interval, accounting for aquifer properties and pumping rate.
Details: Accurate drawdown calculation is crucial for groundwater resource management, well design, aquifer characterization, and predicting the effects of pumping on groundwater levels.
Tips: Enter all values in the specified units. Drawdown values should be in meters, discharge in cubic meters per second, transmissivity in square meters per second, and time values in seconds. All values must be positive.
Q1: What is drawdown in hydrogeology?
A: Drawdown is the reduction in hydraulic head observed at a well in an aquifer, typically due to pumping a well as part of an aquifer test or well test.
Q2: When is this equation applicable?
A: This equation is applicable for confined aquifers with homogeneous and isotropic properties, and for wells that fully penetrate the aquifer.
Q3: What are typical transmissivity values?
A: Transmissivity values range from less than 1 m²/day for poor aquifers to over 1000 m²/day for excellent aquifers. The units should be consistent in calculations.
Q4: What are the limitations of this equation?
A: The equation assumes ideal conditions: homogeneous isotropic aquifer, fully penetrating well, and negligible well storage effects. Real-world conditions may require more complex models.
Q5: How does time affect drawdown?
A: Drawdown typically increases with pumping time, but the rate of increase decreases over time as the cone of depression expands and stabilizes.